MOUNTING INSTRUCTIONSMOUNTING INSTRUCTIONS
B Copyright SIRIO antenne - Technical Data are subjected to change - Printed in ITALY - Rev. 16/10/2008 - Cod. ID042
Freq. (MHz)
26.4
27.0
(Ch.19 CB) 27.185
27.5
28.0
28.2
L (mm)
545
381
330
241
101
45
L
4
6
5
TUNING TABLETUNING TABLE
11
33
22
44
HI-QUALITY ANTENNAS MADE IN ITALY
1
2
3
Mount the bottom
section with coil (7) on
the mast using parts
(8), (9), (10) and (11) in
according to the
picture.
Parts List
Pos Q.ty Description
1 1 5 sections telescopic aluminium whip
2 4 plastic jointing sleeves (4 different sizes)
38Æ 3.9x6.5 mm phillips tapping screws
4 1 top section with cage
5 1 M4x4 hexagon socket set screw cup point
6 1 2 mm hexagonal key
7 1 Bottom section assembled with coil and connector
8 6 M8 washers
9 6 M8 spring lock washers
10 6 M8 hexagonal nuts
11 3 M8x200 mm U-bolts
12 1 Æ 26-28 mm hose clamps
13 8/12 Æ 6x8x1320mm radials aluminium tubes with joint (SIRIO 2008/12)
16 Æ 6x8x700mm radials aluminium tubes with joint (SIRIO 2016)
14 8/12/16 PVC cap for Æ 8mm aluminium tubes (models dependent)
Pull out the sections of
telescopic aluminium whip (1),
insert the jointing sleeves (2) and
lock they using the screws (3).
Insert the top section with the
cage (4) at L (see tuning table for
frequency) and lock it using the
screw (5) and 2 mm hexagonal
key (6).
NOTE: Use the table just as a
guide. For fine-tuning please use
an SWR-meter
1
Mast Æ 40-50mm (not supplied)
Fit the whip (1) on the
bottom section (7). Well
lock the hose clamps
(12) by using the
suitable 8mm open key.
Mount the PVC cap (14)
at the end of radials
tubes (13) and lock they
on the coil by using the
suitable 10mm open key.
10
9
11
7
1
7
12
13
14
n. 1 tape rules (meter)
n. 1 phillips screwdriver
n. 1 8 mm open key
n. 1 10 mm open key
n. 1 13 mm open key
Mounting needed tools:
8
5 SECTIONS TELESCOPIC ALUMINIUM WHIP
Comments to this Manuals